If someone would like to make helical versions of these and share them here that would be great. ![]() ![]() However, since these models are easy to use for any straight gear I need there is no downside, plus they are great for 3D printing or even FEA if undercuts and radii are properly done. As with threads on a fastener, often times it is unnecessary to model something with such detail, since the specification governs and not the geometry. They are offered simply as a good starting point for someone, but the ultimate responsibility is yours in using these models. These models DO NOT deal with undercuts that would occur when there are few teeth, and specifics of the root and tip radius are up to the user. They are very good for the involute profile. ![]() These gears use a Design Table where you input the number of teeth, pressure angle, and module (metric) or diametral pitch (inch).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |